SWIFT ULTRASLIDE REPOSITIONING SYSTEM

The Swift UltraSlide System is a cost-effective, low-friction repositioning system intended to allow caregivers to safely and easily perform manual handling tasks with little physical strain. Implementing the standard use of this system will create a safer healthcare environment for caregivers, ensure the comfort and security of patients/residents, and assist in supporting your facility’s no-lift policies.

– Designed and developed in partnership with a practicing Physiotherapist

– It’s Ultra Thin breathable fabrics make the device suitable to remain under the patient at all times, without any negative impact on the performance of specialty mattresses

– Swift provides not only an appropriate tool for caregivers to safely reposition, boost or turn a patient but also provides comfort and dignity to the patient

The Swift Ultra Slide system is a friction reducing device that remains in-situ to assist with patient/resident repositioning, boosting and turning in bed. Made with a breathable, low-friction backing it allows staff to reposition patients/residents safely and easily whilst avoiding heat build up under the patient/resident. The Swift Ultra Slide systems thin profile will not impair the performance of pressure redistribution mattresses and can therefore remain on the bed when not in use (tucked in), making it readily available when needed.

– Standard Swift Ultra Slide system – designed for both standard and bariatric use. The central panel should support patient/resident from neck to just below the buttocks

– Full Length Swift Slider – designed for both standard and bariatric use. The Full Length Swift Slider supports the full length of a patient/ resident. When the slider is tucked in (not in use) the Slider has the visual appeal of standard bedding.

The Swift UltraSlide System uses the UltraSlide Bottom Sheet in conjunction with the Swift Sliders for use with more dependent patients/residents who have little or no moblity and require extensive or total assistance for repositioning.

For all repositioning and manual handling solutions it is recommended to seek advice / approval from a manual handling expert.

NOTE: Inspect before use for signs of wear-and-tear and replaced as necessary. Fabric, thread and stitch degradation will take place over time (as normal wear and tear) that will reduce the slide capacity.